Product description
Not sure if you'll like it? See what Mike Phillips has to say about itHERE!
A defensive barrier against contaminants and harm!
DP CR2 Ceramic Coating contains a 7H hardness rating that is designed to last for up to two years of protection. DP CR2 Ceramic Coating creates an extremely hydrophobic surface with self-cleaning properties. DP CR2 Ceramic Coating also provides a protective barrier against contaminants Ceramic coatings are some of the most well talked about products in the detailing world. With benefits like making your vehicle more resilient, easier to clean and enhanced gloss, it's easy to see why it's so highly regarded. So, if you're looking to capture these three features, look to DP CR2 Ceramic Coating.
What to expect:
• PROTECTION! 7H hardness rating that can last up to two years.
• HYDROPHOBICITY! Intense water beading allowing for self-cleaning.
• GREAT LOOK! Nano-crystalline properties gives a slick, seek shine.
DP CR2 Ceramic Coating features an impressive 7H hardness rating, meaning that this coating will help prevent against environmental contaminants from creating a hold on your paint and thus causing damage. It is protective against UV rays, industrial fallout and other environmental hazards. Not only that, but water, dirt and other lighter contaminants will slide off of the surface. Besides being extremely protective and durable, DP CR2 Ceramic Coating is also extremely hydrophobic. This hydrophobic surface will allow water to bead up and roll off rather than stick around and create water spots on your paint. While it won't permanently rid your car of water spots, it will help prevent them a great deal. Best of all, this protection will last up to two years! Plus, DP CR2 Ceramic Coating is a nano-crystalline coating which means that it provides not only the protection mentioned, but also a slick, sleek shine. So, your car look great and it will stay that way!
DIRECTIONS:
-Wash, dry, and correct paint if needed.
-Shake well before use.
-Use DP Coating Prep Spray to remove any oils that would prevent proper bonding.
-Apply several drops of product onto a microfiber applicator
-Apply to a 3 x 3 sq. ft. area in a back and forth, cross-hatch pattern.
-Allow for slight overlay to ensure even coverage.
-Allow area to set for approximately 30-60 seconds and then gently remove excess product.
-A second coat can be applied after approximately 1 hour.
-Keep coated surfaces dry for 24-48 hours for best results.
30 ml.
Federal regulations prohibit the shipment of this products by air, 3 Day, 2 Day, or US Mail. This item is shipped by Ground only. Sorry but no APO or FPO addresses.
.Product Related
