Diamondite Headlight Lens/ Clear Plastic Restoration Guide

The Diamondite Clear Plastic Kit is a three step system to restore, clean, and protect your vehicle's headlights. The system works with an electric drill or polisher using the included 4 inch pads. Remove cloudiness and oxidation caused by UV exposure, as well as light scratches and imperfections with the Diamondite Clear Plastic Kit.

The Diamondite Clear Plastic Kit includes:

• 4 oz. Diamondite Clear Plastic Enhancer
• 4 oz. Diamondite Clear Plastic Restorer
• 4 oz. Diamondite Clear Plastic Liquid Armor
• 4 inch Yellow Foam Cutting Pad
• 4 inch Orange Foam Light Cutting Pad
• 2 3/4 inch backing plate
• Drill adapter
• Cobra Microfiber Towel
• Instructions

Before you begin…

Tape off the area surrounding the headlights using painter's tape. Clean off any loose debris using Diamondite Perfect Vision Glass Cleaner and a soft microfiber towel. Screw the drill adapter into the included backing plate and tighten with a wrench. Insert the adapter into your electric drill and tighten the chuck.

Step 1
Clear Plastic Enhancer

1. Press the included yellow cutting pad onto the backing plate. Apply Diamondite Clear Plastic Enhancer in an X pattern across the pad.

• If you are using a drill or rotary polisher, set the maximum speed at 1800 RPM.

2. Work in an overlapping motion until cleaner breaks down into a clear film. Work up and down and side to side. There is no need to apply pressure to the machine.
3. Use the included soft microfiber towel to remove residue. Severely stained or scratched lenses may require a second treatment.

• Note: Avoid polishing over the alignment dowels on the lens cover as they could tear the pad.

Step 2
Clear Plastic Restorer

1. Remove the yellow cutting pad and attach the included orange light cutting pad. Dispense Diamondite Clear Plastic Restorer in an X pattern across the orange pad.
2. Work at a speed of 1800 RPM on your electric drill. Move the pad up and down and side to side for complete coverage. When the polish starts to dry, turn off the drill and slowly lift it off the headlight lens cover.
3. Wipe the headlight clean with the included microfiber towel. Repeat step 2 if necessary.

Step 3
Clear Plastic Liquid Armor

1. Mist the headlight lens with Diamondite Clear Plastic Liquid Armor . Two or three pumps should be enough to cover the lens.
2. Use a microfiber towel to spread the sealant over the lens and flip the towel to buff dry.
3. Allow the sealant to cure for an hour and then apply another coat if desired.

Maintain the clear shine of your polished plastic headlights with Diamondite Plasti-Care Plastic Cleaner, Polish & Protectant. This aerosol spray cleans and shines plastic headlight covers, and it leaves a anti-static coating to keep them clean longer.