|Clean and protect all types of wheels!|
Brake dust is the single most destructive contaminant that plagues your motorcycle’s wheels. It contains carbon and an adhesive used in the manufacture of brake pads. Add red hot metal shavings to the mix and you’ve got a recipe for corrosion.
DP Wheel Glaze is designed to prevent the adhesion of brake dust to your motorcycle’s wheels. In fact, it prevents road grime from sticking to many surfaces on your bike. Any metal component that does not get hot can be treated with Wheel Glaze.
DP Wheel Glaze is a cleaner and a polymer sealant that removes light contamination from the wheel surface and creates a shiny protective coating. The cleaning agents remove dirt, brake dust, tar, sap, and bugs while improving fine scratches. Wheel Glaze even reaches into microscopic holes created by brake dust to remove it entirely. Neglected wheels will appear clean and clear, like new wheels.
As Wheel Glaze cleans, it deposits a clear, glossy layer of polymers on the wheel surface. This coating blocks out the sun, sand, salt, snow, acid rain, industrial pollution, tar, and – the worst culprit of all – brake dust. The wheel surface will be so slick that brake dust will be unable to stick. Your wheels will remain clean longer, even in adverse conditions. Wheel Glaze resists high heat, humidity and extreme cold.
DP products have been researched and tested in sunny South Florida. In these hot and often wet conditions, we found that DP Wheel Glaze does not evaporate prematurely or weaken. It continues to keep your wheels clean, shiny, and protected from the threat of corrosion.
A coating of DP Wheel Glaze every 6-8 weeks will make washing your motorcycle much easier. Since nothing sticks to the slick coating, you can wash bugs, brake dust, and oily grime off with just soap and water.
- DP Wheel Glaze should be applied to cool wheels out of direct sunlight.
- Clean excessively dirty wheels with DP Gel Wheel Cleaner. Rinse and allow to dry before applying Wheel Glaze.
- Use a terry cloth or polyfoam applicator to apply Wheel Glaze to wheel surface. Allow a haze to form and then buff to a shine with a Cobra Microfiber Towel. Mist the wheel with water and buff again to achieve the best results.
- You will need to apply DP Wheel Glaze at least every 6-8 weeks. Wash with only soapy water or a gentle cleaner like S100 Total Cycle Cleaner to preserve the coating for as long as possible. If you clean with a tire cleaner, you will need to reapply DP Wheel Glaze.